Changes to Step #10

Edit by Rat Rig —

Edit approved by Rat Rig

Before
After
Unchanged

Step Lines

[title] Assemble the Y joiner plate
[* 2] Rat Rig Mill - Y Gantry Plate
[* 10] Ensure that the Y gantry plate is not mistaken for the X gantry plate. The X gantry plate features M3 threaded holes along its edges, whereas the Y gantry plate does not.
[* 3] Nut Block for TR8x8 assembly from the last step.
[* 10] The M5 Nylon Locking Hex Nuts, must be facing away from the Y gantry plate.
[* 4] Gently tighten the M5x16 Low Head Screws on the designated holes.
+[* 9] Do not overtighten the screws as it will cause binding in the lead screw. Tighten until the nut block is flush with the plate and add half a turn on the screws.
[* 5] Thread the M5x16 Low Head Screws on the designated slot, Do not tighten this Nut Block, it will be adjusted later.
[* 10] These Screws must be installed on the M5 slot in the Y gantry plate.