| | [* 3] After positioning the jog wheel, tighten the two set screws to secure it in place. |
|---|
| | [* 10] Pull the X joiner plate away from the jog wheel, as to ensure the jog wheel and thrust bearing sit tight against the front Y plate. |
|---|
| | [* 9] Excessive force is unnecessary, as it may cause the lead screw to bind. |
|---|
| | [* 4] Push the lock collar against the Y front plate. |
|---|
| | [* 5] Tighten the set screw on the lock collar to secure it in place. |
|---|
| | [* 6] Install the Thrust Bearing on to the exposed end of the Lead Screw as shown |
|---|
| | [* 7] Install the Coupler - Disk Type on to the exposed end of the Lead Screw as shown |
|---|