Changes to Step #9
Step Lines
| + | [title] Assemble the Z plate |
|---|---|
| + | [* 2] Rat Rig Mill - Z Plate |
| + | [* 3] Nut Block for TR8x4 assembly from the last step. |
| + | [* 10] The M5 Nylon Locking Hex Nuts, must be facing away from the Y gantry plate. |
| + | [* 4] Gently tighten the M5x16 Low Head Screws on the designated holes. |
| + | [* 9] Do not overtighten the screws as it will cause binding in the lead screw. Tighten until the nut block is flush with the plate and add half a turn on the screws. |
| + | [* 5] Thread the M5x16 Low Head Screws on the designated slot, Do not tighten this Nut Block, it will be adjusted later. |
Image 1
No previous image
Added
Image 2
No previous image
Added