Changes to Step #22
Step Lines
| + | [title] Install the tramming screws |
|---|---|
| + | [* 2] 4x M6x8 Set screws |
| + | [* 10] Look through the threaded holes; there should be no light visible on the other side. If you see light, it indicates that one of the Z plates is installed upside down. Please review the correct installation steps to resolve this. |
| + | [* 3] Lightly thread the set screws into the designated holes. Once they reach the rear Z plate, stop tightening. |
| + | [* 11] These screws are intended to assist the user in tramming the spindle during the commissioning process. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added