Changes to Step #22
Step Lines
| [title] Install the tramming screws | |
| [* 2] 4x M6x8 Set screws | |
| - | [* 10] Look through the threaded holes; there should be no light visible on the other side. If you see light, it indicates that one of the Z plates is installed upside down. |
| + | [* 10] Look through the threaded holes; there should be no light visible on the other side. If you see light, it indicates that one of the Z plates is installed upside down. Visit this [guide|285|stepid=3134] and flip the Z plate upside down. |
| [* 3] Lightly thread the set screws into the designated holes. Once they reach the rear Z plate, stop tightening. | |
| [* 11] These screws are intended to assist the user in tramming the spindle during the commissioning process. |