Changes to Step #5
Step Lines
| + | [title] Route the Z axis Stepper wires |
|---|---|
| + | [* 6] Route the Z-stepper wires as shown in the picture. |
| + | [* 6] Use a zip tie to constrain it to the mill_stepper_cable_managment printed part, then through the mill_z_tower_top printed part and inside the Z tower. Finally exit at the rear, above the Y stepper and into the electronics enclosure or your desired location. Leave an extra 300mm (at least) to route it to the controller and crimp the connector. |
| + | [* 4] Cut the wires to the final length, double check if the cable has the appropriate length before cutting. |
| + | [* 5] Label the cable at the end, with a piece of duct tape for example. |
| + | [* 2] Crimp the JST-XH into the wires ensuring the crimp has a solid connection to the wire core. |
| + | [* 3] Inset the crimps into the JST-XH housing, follow the wire colour scheme to preserve the motor coil pairs |
| + | [* 9] Should the integrity of the motor coil pairs not be maintained, the motor will experience impaired operational functionality. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added