Changes to Step #10
Step Lines
| + | [title] Route the X axis endstop cable |
|---|---|
| + | [* 6] Route the X endstop cable as shown in the picture. |
| + | [* 6] Use a zip tie to constrain it to the mill_stepper_cable_managment printed part, through the 4016 X gantry using the mill_4040_t_slot_clip to secure them. Exit at the mill_x_umbilical_mount printed part, and into the electronics enclosure or your desired location. Leave an extra 300mm (at least) to route it to the controller and crimp the connector. |
| + | [* 4] Cut the cables to the final length, double check if the cable has the appropriate length before cutting. |
| + | [* 5] Label the cable at the end, with a piece of duct tape for example. |
Image 1
No previous image
Added
Image 2
No previous image
Added