Changes to this Step

Edit by Rat Rig —

Edit approved by Rat Rig

Before
After
Unchanged

Step Lines

[title] Install the Rodent
[* 2] Install the component using the designated holes.
[* 3] 4x Hex Locking Nut - M3
[* 4] 4x Nylon Spacer - 3.2x6x16mm
[* 5] BigTreeTech & Rat Rig - Rodent CNC Controller TMC2160
[* 6] 4x M3x25 Cap Head Screw
+[* 10] Insert the M3x25 cap head screws through the rodent and nylon spacers, then through the designated holes on the plate. Finally, secure them by fastening to the M3 hex locking nuts on the back.