Changes to Step #2

Edit by Rat Rig —

Edit approved by Rat Rig

Before
After
Unchanged

Step Lines

[title] Install the contactor
[* 2] Install the component using the designated holes.
[* 3] 4x Hex Locking Nut - M4
[* 4] CNC Electronics Contactor
[* 5] 4x M4x16 Cap Head Screw + M4 washer
+[* 10] Insert the M4x16 cap head screws with M4 washers into the contactor mounting holes, then through the plate. Finally, secure them by fastening to the M4 hex locking nuts on the back.