Changes to this Step

Edit by Rat Rig —

Edit approved by Rat Rig

Before
After
Unchanged

Step Lines

[title] Assemble the rear panel - Part 1
[* 2] Rat Rig Universal CNC Electronics Enclosure - rear
[* 3] (8x) M5x12 Cap Head Screw + M5 Washer
[* 4] 8x 3030 Drop-in T-Nut - M5
-[* 10] Insert a M5x12 Cap Head Screw into each marked hole on the right panel and loosely tighten a M5 drop-in T-nut to each screw.
+[* 10] Insert an M5x12 Cap Head Screw into each marked hole on the right panel and loosely tighten a M5 drop-in T-nut to each screw.
[* 5] Insert the rubber grommets into the panel.