Changes to this Step

Edit by Rat Rig —

Edit approved by Rat Rig

Before
After
Unchanged

Step Lines

[title] Assemble the door panel - Part 1
[* 2] Rat Rig Universal CNC Electronics Enclosure - Door
[* 3] (8x) M6x12 Cap Head Screw + M6 Washer
[* 4] Door magnet panel assembly
[* 10] Feed the M6x12 Cap Head screws through the M6 washers and into the door panel, then tighten them onto the hex locking nuts on the door magnet panel assembly.
-[* 9] Take care not to over tighten the M6x12 screw as you can damage the printed parts
+[* 9] Take care not to overtighten the M6x12 screw, as you may damage the printed parts.
[* 5] (4x) M5x16 Cap Head Screw + M5 Washer
[* 6] V-Slot Door Handle
[* 7] (4x) M5 Hex locking nut + M5 washer