Changes to Step #7
Step Lines
| [title] Prepare the Emergency button | |
| [* 2] Open the emergency button by removing the four screws | |
| [* 3] Open a hole on the emergency button body, either by snapping a removable disk or drilling a hole | |
| [* 5] Insert the fork end of ***wire (0)*** into the shown terminal. | |
| [* 7] Insert the fork end of the ***wire (1)*** and the fork end of ***wire (2)*** into the shown terminal | |
| - | [* 8] Tighten the screws on the terminals and try to pull the wires out to check if the connection is secure. |
| + | [* 8] Tighten the screws on the terminals. |
| + | [* 9] After insertion, attempt to pull the wire to verify that it is securely attached. |
| [* 10] Install the black cover on the E-stop button, don't use the screws. |