Changes to Step #11

Edit by Rat Rig —

Edit approved by Rat Rig

Before
After
Unchanged

Step Lines

[title] Wire the E-stop button
-[* 2] Insert wire (0) from the E-stop button into the panel hole. Guide it through the shown path and insert the ferrule end into the +24V PTFix block.
+[* 2] Insert ***wire (0)*** from the E-stop button into the panel hole. Guide it through the shown path and insert the ferrule end into the*** +24V PTFix block***.
[* 9] After insertion, attempt to pull the wire to verify that it is securely attached.
-[* 3] Insert wire (1) from the E-stop button into the panel hole. Guide it trough the shown path and insert it back into the designated slot. Lastly, secure the fork connector on the 14NO terminal of the Contactor.
-[* 4] Insert wire (3) from the start button into the panel hole. Guide it through the shown path and insert it back into the designated slot. Lastly, secure the fork connector on the A1 terminal of the Contactor.
+[* 3] Insert ***wire (1)*** from the E-stop button into the panel hole. Guide it trough the shown path and insert it back into the designated slot. Lastly, secure the fork connector on the ***14NO terminal of the Contactor.***
+[* 4] Insert ***wire (3)*** from the start button into the panel hole. Guide it through the shown path and insert it back into the designated slot. Lastly, secure the fork connector on the*** A1 terminal of the Contactor.***
[* 9] After insertion, attempt to pull the wire to verify that it is securely attached.