04. Advanced Bundle Step #21 History - Rat Rig

Changes to Step #21

Edit by Rat Rig — Mar 21, 2025

Edit approved by Rat Rig

: Before
: After
: Unchanged

Step Lines

	[title] Wire the following components
+	[* 10] Route the wires on the back of the enclosure as shown.
	[* 2] *700mm - 16AWG RED (A-Ferrule, B-Ferrule) (4) *Connect the wire from the start button (in) to the I1+ terminal on port2 of the AXBB-E
	[* 3] *700mm - 16AWG BLACK (A-Ferrule, B-Fork) (5)* Connect the ferrule in the Black PTFix block and the fork on the A2 terminal of the contactor.
	[* 4] *600mm - 16AWG RED (A-Fork, B-Ferrule) (7)* Connect the ferrule into the Red PTFix block, the fork end should have been connected to the power supply [guide\|298\|here.\|stepid=3301]
	[* 5] *600mm - 16AWG BLACK (A-Fork, B-Ferrule) (8)* Connect the ferrule into the Black PTFix block, the fork end should have been connected to the power supply [guide\|298\|here.\|stepid=3301]
	[* 6] *150mm - 22AWG BLACK (A-Fork, B-Ferrule) (9)* Connect one end of the wire to the Black PTFix block and the other to the I1- terminal on port 2 of the AXBB-E
	[* 8] *120mm - 16AWG RED (A-Fork, B-Fork) (6)* Connect the wire from terminal 13NO on hte contactor to the A1 terminal on the contactor. A1 should have 2 Forks inserted.