Changes to Step #23
Step Lines
| + | [title] Wire the following components |
|---|---|
| + | [* 11] Ignore Y2 if you are wiring a Rat Rig Mill. ***Repeat the Steps to connect all drivers.*** |
| + | [* 2] ***4x 550mm - Multicore 3 Conductor - 24AWG BLACK (A-(3x)Ferrule, B-(3x)Ferrule) (14)*** |
| + | [* 10] ***DRIVER SIDE:*** Connect the white wire to ***PUL+*** , the green wire to ***DIR+*** and the brown wire to ***DIR-*** |
| + | [* 10] ***AXBB-E Side:*** Connect the white wire to ***09*** , the green wire to ***010*** and the brown wire to the Black PTFix Block |
| + | [* 10] Follow the order and connect stepper ***Y( PUL+ to 011, DIR+ to 012)***, then ***Z( PUL+ to 013, DIR+ to 014)***, Lastly ***Y2( PUL+ to 015, DIR+ to 016)*** |
| + | [* 5] ***4x 30mm - 22AWG BLACK (A-Ferrule, B-Ferrule) (17)*** To jump ***DIR-*** with ***PUL-*** |
| + | [* 3] ***4x 800mm - 16AWG RED (A-Fork, B-Ferrule) (15)*** The Fork terminals should be already wired to the 48V Power supplies [guide|298|here.|stepid=3305] Then connect it to +VDC on the driver. |
| + | [* 4] ***4x 800mm - 16AWG BLACK (A-Fork, B-Ferrule) (16)*** The Fork terminals should be already wired to the 48V Power supplies [guide|298|here.|stepid=3305] Then connect it to GND on the driver. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added