Changes to Step #4

Edit by Rat Rig —

Edit approved by Rat Rig

Before
After
Unchanged

Step Lines

[title] Install the rear panel
[* 2] Feed all the stepper motor cables through the designated hole on the rear panel. Then insert them into the components upper panel slot, as shown.
[* 10] Connect them into the designated slots.
[* 7] Feed all the endstop cables through the designated hole on the rear panel. Then insert them into the components upper panel slot, as shown.
[* 10] Connect them into the designated slots.
[* 4] Feed the spindle cable through the designated hole on the rear panel. Then insert them into the components lower panel slot, as shown.
-[* 5] the cables should be inserted into the rear panel here.
+[* 5] The cables should be inserted into the rear panel here.