| | [* 2] Feed all the stepper motor cables through the designated hole on the rear panel. Then insert them into the components upper panel slot, as shown. |
|---|
| | [* 10] Connect them into the designated slots. |
|---|
| | [* 7] Feed all the endstop cables through the designated hole on the rear panel. Then insert them into the components upper panel slot, as shown. |
|---|
| | [* 10] Connect them into the designated slots. |
|---|
| | [* 4] Feed the spindle cable through the designated hole on the rear panel. Then insert them into the components lower panel slot, as shown. |
|---|
| | [* 5] The cables should be inserted into the rear panel here. |
|---|
| | [* 11] Y2 Should only be connected if you are wiring a StrongHold Machine, it's not used in the Mill. |
|---|