Changes to Step #5

Edit by Rat Rig —

Edit approved by Rat Rig

Before
After
Unchanged

Step Lines

[title] Attach the Y rails
-[* 10] Do not bolt down all of the screws yet, just secure the rail by the two screws on the ends - later adjustment maybe required
+[* 10] Do not tighten down all the screws yet, just attach the rail by the two screws on the ends - later adjustment maybe required
[* 1] Attach the Y MGN 12 rails on both sides of the printer
[* 1] Use the 3030 corner bracket in the back as reference - the rail should touch the bracket
-[* 2] Measure the space between the side of the rail and the side of the extrusion - for 3030 it should be 9.00mm on each side - measure each rail in 4 points
+[* 2] If you don't have the MGN Alignment Tool, measure the space between the side of the rail and the side of the extrusion - for 3030 it should be 9.00mm on each side - measure each rail in 4 points