Editing Step 2 —
Assemble the Main Body

Notice: You are editing a prerequisite guide. Any changes you make will affect the guide that includes this step.

Step Type:

Drag to rearrange

3030 Extrusion - 234mm

Install the two 90 degree corners on to one end of the 3030 extrusion.

Tighten the M6x12 cap head screws connecting to the 3030 extrusion using a 5mm hex key.

Make sure the 90 degree corners are both flush, and square, with the end of the extrusion. before tightening

Your contributions are licensed under the open source Creative Commons license.