Editing Step 7 —
Assemble the rear feet

Step Type:

Drag to rearrange

side_legs printed part

2x M5 Nylon Locking Hex Nut

2x Rubber Foot

Fasten the two M5x25 screws through the rubber foot and into the M5 nylon locking nuts

Take care not to over tighten the M5x25 screws as you can damage the printed part.

3x M6x12 Cap Head Screw

3x 3030 Drop-in T-Nut - M6

Loosely thread the 3030 T-Nuts onto the M6x12 screws. Do not tighten them at this point.

Your contributions are licensed under the open source Creative Commons license.