03. Addons and Upgrades V-Core 3
View
Options
Preview new Authoring Experience
History
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
Introduction
Details
Guide Steps
Review
Quiz
Make sure the belt is properly seated on all idlers and pulleys.
Mark the belt where it meets the Rat Rig toolhead assembly. This can be done with a marker, or simply by holding it.
From the mark, towards the loose end of the belt, measure 23mm (or count 12 teeth)
It is better to cut the belt too long than too short! If you are unsure, cut it longer than expected, you can always remove more if needed
Double check your measurements and then cut the belt at this point
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.