Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect the guide that includes this step.

Step Type:

Drag to rearrange

rr_vc4_toolhead_fan_grille

2x M3x35 Cap Head Screw

Feed the M3x35 cap head screws through the grille (pay close attention to its orientation), the aluminium plate and the 4028 fan, tightening them into the back printed part.

Take care not to over tighten the screws as you can damage the printed parts

Avoid using a ball end hex key, as they are more prone to damaging the sensitive M3 countersink screw head.

Your contributions are licensed under the open source Creative Commons license.