Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect the guide that includes this step.

Step Type:

Drag to rearrange

Rat Rig toolhead front belt clamp

Lever the belt clamp against the exposed screw section and place it inside the belt slot.

M4x10 Countersink Screw

Tighten the M4x10 screw making sure the teeth of the belt clamp mesh with the belt

Pay attention to seating the notch on the belt clamp on the exposed screw section. Pull on the belt to make sure it's secured properly.

Take care not to over tighten the screws as you can damage the printed parts

Your contributions are licensed under the open source Creative Commons license.