Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect the guide that includes this step.

Step Type:

Drag to rearrange

Feed the belt inside the slot on the back part of the toolhead.

Leave 10-20mm of the belt tip extending out to allow for easy manipulation during assembly.

Rat Rig toolhead back belt clamp

M3x35 Cap Head Screw

Tighten the M3x35 cap head screw while securely holding the belt end to prevent it from being pulled in.

Cut the excess belt.

Your contributions are licensed under the open source Creative Commons license.