Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect the guide that includes this step.

Step Type:

Drag to rearrange

Insert the 2.5mm Cap Head Screws back in and tighten them.

DO NOT overtighten the screws, they are only 2.5mm and will break if excessive force is applied.

Tighten the set screw back in

DO NOT overtighten the screw, if excessive force is applied the heatbreak will be permanently damaged.

Put the socket back on.

Try to insert the hotend on the toolhead and see if the cables align with the designated slot, if not, repeat Steps 21, 22 and 23 and try a different angle in Step 22

Your contributions are licensed under the open source Creative Commons license.