Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect the guide that includes this step.

Step Type:

Drag to rearrange

This image references the single toolhead version, but the procedure is the same. The goal is to verify if the rapido wires align with the toolhead slot.

Phaetus Rapido V2 UHF

Place the Phaetus Rapido V2 UHF Hotend on the plate, making sure to route the cables through the designated slot

Look from above and see if all four holes line up correctly.

All the holes on the plate, hotend and printed part should line up:

If they align skip to Step 26

If they don't align follow the next steps

Your contributions are licensed under the open source Creative Commons license.