Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect the guide that includes this step.

Step Type:

Drag to rearrange

LDO Orbiter V2

2x M3x8 Cap Head Screw

Carefully align the extruder with the PTFE tube.

Insert the M3x8 screws into the LDO Orbiter V2 and fasten them to the Rat Rig toolhead plate.

Take care not to over tighten the M3x8 screws as you can strip the toolhead plate threads

Thread the hex standoff on to the LDO Orbiter V2 screw.

Do not overtighten the hex standoffs. They are brass and it is possible to strip the threads.

Your contributions are licensed under the open source Creative Commons license.