Skip to main content
Help

Pending Edits to 07. EVA Assembly

Note: Accepting or denying any edit implicitly applies to all earlier pending edits to the same step or introduction.

Step #5 edited: [Step edited]

Edited by Chris White (1)

(You don’t have enough reputation to patrol this edit.)

(These edits result in no net change and should be denied.)



Introduction edited

Edited by Stan Stocker (3)

(You don’t have enough reputation to patrol this edit.)

Time Required Min
3 hours
Time Required Max
3 hours
Difficulty
Moderate
Difficult
Conclusion
Check the hole for the PTFE filament guide in the printed extruder support and clear it as needed BEFORE you mount the extruder. I didn't and had to backtrack. No guidance on which way to mount the fan that cools the heatsink either, hope I got it right The fan body has no arrows for spin or flow. I THINK flow is towards the label, other fans here are like this.