Pending Edits to 05. CoreXY Motor Assemblies
Note: Accepting or denying any edit implicitly applies to all earlier pending edits to the same step or introduction.
Step #16 edited: [Step edited]
Edited by Kaushik Rajan (1)
(You don’t have enough reputation to patrol this edit.)
| [title] Install the right CoreXY motor cage - Part 2 | |
| [* 2] Loose end of the bottom CoreXY belt | |
| - | [* 3] Form a loop as shown, |
| + | [* 3] Form a loop as shown, with the toothed side of the belt facing the frame and the smooth side facing the bearing stacks. This will be used to engage with the NEMA17 motor pulley |
| [* 4] Position the bottom belt as shown | |
| [* 5] Loose end of the top CoreXY belt | |
| [* 6] Slot this end of the top CoreXY belt around the top bearing stack as shown | |
| [* 9] Make sure that both belts match the third image before proceeding |
Introduction edited
Edited by Josh Ward (2)
(You don’t have enough reputation to patrol this edit.)
| Time Required Min |
2 hours
|
|---|---|
| Time Required Max |
2 hours
|
Introduction edited
Edited by Astrodork (3)
(You don’t have enough reputation to patrol this edit.)
| Summary |
|
|---|