Pending Edits to 04. V-Core 3.2H Upgrade kit
Note: Accepting or denying any edit implicitly applies to all earlier pending edits to the same step or introduction.
Step #171 edited: [Step edited]
Edited by JJ_Ramsey (1)
(You don’t have enough reputation to patrol this edit.)
| [title] Prepare the Rapido Hotend | |
| [* 9] ***Please note***: The wire colours shown in the image are for illustration purposes only | |
| [* 2] ***Hotend Heater - Shown in red***: Cut the wires to a length of 150mm and strip 5-10mm off the end, to expose the inside conductor | |
| - | [* 7] ***Thermistor - Shown in blue***: Cut the wires to a length of 160mm and crimp a JST |
| + | [* 7] ***Thermistor - Shown in blue***: Cut the wires to a length of 160mm and crimp a JST-XH connector to them |
| [* 10] The thermistor is a resistor that varies with temperature. The wire order does not matter when attaching the JST connector as a resistor does not have a polarity |
Step #20 edited: [Step edited]
Edited by JJ_Ramsey (1)
(You don’t have enough reputation to patrol this edit.)
| [title] Remove the front idler assemblies - Part 1 | |
| + | [* 9] The front idlers keep the Y-axis rail carriage from sliding off the end of the rail. It may be wise to take measures to keep the carriage from sliding off accidentally. |
| [* 2] This step, and the next two steps, detail removing the ***front left*** idler assembly | |
| [* 3] Unscrew, and remove, the top M5 nylon locking nut |
Step #19 edited: [Step edited]
Edited by JJ_Ramsey (1)
(You don’t have enough reputation to patrol this edit.)
| [title] Remove the bed assembly | |
| [* 9] ***Before proceeding***, take note of where the bed heater is connected. This will be needed when reinstalling the bed assembly later in the guide. Taking a photo would be wise | |
| [* 10] Disconnect the heated bed thermistor from the Octopus mainboard, as well as the AC connections from the PSU and SSR | |
| [* 10] Feed the bed wiring back through the rear panel | |
| [* 2] Remove the zip ties securing the bed wiring to the rear Z-axis arm | |
| [* 3] Lift the bed assembly upwards from the Z-axis arms | |
| - | [* 4] Carefully remove the bed |
| + | [* 4] Carefully remove the bed assembly from the machine and store it somewhere safe. |