Pending Edits to 01. Frame assembly
Note: Accepting or denying any edit implicitly applies to all earlier pending edits to the same step or introduction.
Step #6 edited: [Step edited]
Edited by Mikael (1)
(You don’t have enough reputation to patrol this edit.)
| [title] Check squareness | |
| [* 8] Make sure the frame is square. The diagonal lengths should be equal | |
| - | [* 3] The middle extrusion should be in the exact middle of the inner frame - 205mm from the side extrusions |
| + | [* 3] The middle extrusion should be in the exact middle of the inner frame - 205mm (or 255mm or 305mm) from the side extrusions |
Step #15 edited: [Step edited]
Edited by Márcio Pereira (1)
(You don’t have enough reputation to patrol this edit.)
| [* 1] Attach the top Y extrusions | |
| [* 10] You will need to loosen the ***corner brackets*** in the top of the inner frame | |
| [* 2] Again, ensure the ***inner frame*** is parallel to the main frame - the distance between those should be 47mm | |
| + | [* 1] Use the ***motor_plates*** (from Part 0.2 XY Drive Assembly) to align the inner frame top position in the correct place. |
Step #13 edited: [Step edited]
Edited by Márcio Pereira (1)
(You don’t have enough reputation to patrol this edit.)
| [title] Attach the inner frame | |
| - | [* 1] Insert the inner frame into the main frame |
| + | [* 1] Insert the inner frame into the main frame. |
| [* 10] You will need to loosen the bottom ***corner assemblies*** a little | |
| [* 2] The distance between the inner frame and the main Z extrusions should be 47mm | |
| + | [* 1] Use the ***motor_plates*** (from Part 0.2 XY Drive Assembly) to align the inner frame bottom position in the correct place. |
Step #4 edited: [Step edited]
Edited by cem yildizak (1)
(You don’t have enough reputation to patrol this edit.)
| [title] Prepare the inner frame 3030 extrusions | |
| [* 10] For the next step you will need: | |
| - | [* 1] 420mm 3030 extrusion |
| - | [* 1] 440mm 3030 extrusion |
| - | [* 1] 450mm 3030 extrusion |
| + | [* 1] 1 X 420mm 3030 extrusion |
| + | [* 1] 2 X 440mm 3030 extrusion |
| + | [* 1] 2 X 450mm 3030 extrusion |
Step #5 edited: [Step edited]
Edited by Mikael (1)
(You don’t have enough reputation to patrol this edit.)
| [title] Electronics Frame | |
| [* 1] Prepare the 3030 extrusions: | |
| - | [* 2] 440mm |
| - | [* 3] 450mm |
| - | [* 6] 420mm |
| + | [* 2] 440mm (540mm, 640mm) |
| + | [* 3] 450mm (550mm, 650mm) |
| + | [* 6] 420mm (520mm, 620mm) |
| [* 5] Attach 6 Corner Brackets to the ends of the vertical extrusions | |
| - | [* 4] 205mm |
| + | [* 4] 205mm (255mm, 305mm) |
| [* 1] Carefully attach the extrusions by tightening all screws on the Corner Brackets. Make sure the frame is perfectly square. A flat surface may help. |