Johan Gislén

If you’re upgrading from a V-Core Pro version without EVA and plan to upgrade X/Y, it’s a good idea to mount the X/Y idlers before mounting the front linear rails - with the linear rails mounted it’s very difficult to tighten the bottom screws holding the idlers.

When mounting the steppers note that the steppers will be flush to the 2040 profile, so orient steppers so that the cable is not in the way when mounting to the frame.

Any ideas on how to get the back motor mount int place with the T-nuts attached? I ended up removing the two T-nuts on the left side (leaving the top two and the M5x10 to the right in place) - and then putting the T-nuts back using pliers when the motor mount was in place. Is there a better way to do it?