peter williams

Raise it up or it feels like it’s binding. I read the the above and forgot the last part. I have no idea how much time I spent trying to figure out why it bound up when it was just hitting the table.

I got a bit further in the build and ran out of M6x12 screws and M6 T-NUTS. I am currently emailing with Pedro to get things sorted. I told him he should visit these comments and straighten it all out cause it is still screwed up. So, right now I would advise you to contact RatRig.

If it is possible some idiot will do it. I pushed a T-Nut past the hole and it fell down the upright. Then I was turning the frame on its front to get it out and the other nut slid and fell down the upright. Turning the whole thing upside down got them out. Bottom line there are lots of ways to screw this up so be careful.

Because of the disagreement on the screw size I contacted RR and Pedro Marreiro <pedro@ratrig.com> said they had changed to M6 bolts and the length should be 12 mm. My panel is on using the M6x12 bolts and it is tightly attached without a problem. My back panel is attached so it is a little tough to get the calipers on it but it appears to be 3.2mm thick. I got my panel from Mandela Rose Works.