Help
Stefan Wilkens
@swilkens
Stefan Wilkens
| 1 | Reputation |
|---|---|
| 0 | Guides |
| Member Since 04/09/2023 | |
| 1 | Reputation |
|---|---|
| 0 | Guides |
| Member Since 04/09/2023 | |
Superglue also works well, these belts are very easy to glue. Be sure the glue is fully dry before feeding.
Inserting the belt into the toolhead grabber is far easier if you pull the belt through much more then needed. This gives you enough length to bend the belt and fit it into the grabber. After it's in place, you can pull the overlength back. I'm not sure how secure this is, the EVA clamp felt much more secure.
my 300 kit came with more than enough (late 2022)
Chapter 05 step 3 (CoreXY Motor plates) should really be done at this point. That step positions the motor plates and they must fit between the frame and the electronics sub-frame.
You can use the motor plates as a spacer to make sure everything fits.