I agree with the earlier comments, this is confusing. I would assume we should tighten screws in every other hole, starting at the jig?
The green step says “Remove the MGN12 3030 alignment tools”. Should this read “Remove the HG15 3030 alignment tools”?
The instructions say to install the Y1 stepper motor cable in the second slot, but the diagram shows it going into the fourth slot.
The wire clips were prepared in step 46, not step 61.
Once they have, you'll be able to view a graph of their reputation gained over time.
Here's a preview of what the graph will look like:
No reputation gained yet.
I agree with the earlier comments, this is confusing. I would assume we should tighten screws in every other hole, starting at the jig?
The green step says “Remove the MGN12 3030 alignment tools”. Should this read “Remove the HG15 3030 alignment tools”?
The instructions say to install the Y1 stepper motor cable in the second slot, but the diagram shows it going into the fourth slot.
The wire clips were prepared in step 46, not step 61.