Help
Nick Dietrich
@rkd21
Nick Dietrich
| 3 | Reputation |
|---|---|
| 0 | Guides |
| Member Since 10/18/2024 | |
| 3 | Reputation |
|---|---|
| 0 | Guides |
| Member Since 10/18/2024 | |
Please adapt these for to include building a printer with the idex upgrade to start with. There is no y-control without the hybrid motors. So the printer commissioning does not work without them.
This is very misleading, if building with the idex upgrade from the beginning you need the hybrid motors and belts to properly control the y-axis. I found out the hard way after an enormous amount of troubleshooting and things not working. Also caused me to damage an end stop which ratrig provides no spares for.
Please go here and grab the latest RatOS, I accidentally did the wrong one and at some point bricked my control board and needed a new one. Not sure if it's because of this but it definitely caused issues. https://github.com/Rat-OS/RatOS/releases
Where would you wire the second cooling fan using this method if you have the idex upgrade?
I would highly recommend wiring this before installing the fans on the printer. Same goes for the other connections, it would be significantly easier to do on the bench than up in the air on the printer.