Reputation over time
It looks like this user hasn't gained any reputation yet.
Once they have, you'll be able to view a graph of their reputation gained over time.
Here's a preview of what the graph will look like:
Reputation Breakdown
No reputation gained yet.
841
UART jumpers is the way to go.
Bottom row shows the placement for one jumper, but a second is shown on the board. Please clarify.
If you have them use either the M3 x 6 countersink or buttonheads to mount the Mobo supports. I used the 8's as directed and they made contact with the board when I mounted it. Board offsets should definitely be taller if 8's are to be used.
Be careful mounting the Octopus brackets. The offset from the enclosure is very small - the M3's can make contact with the MoBo if the inserts are too deep.
Needed the sanity check reconnecting the 4028 fan.
Standard DuPont connector on the other ends?
Do yourself a favor and skip to Step 65 in "Electronics" before mounting this fan. Major surprises in store!
Please update the routing schemes will colors much easier to discern which is which - e.g.: Black, Red, Green or Red, Green, yellow.
Many thanks to Sebastian/Scott for identifying which Z motor was which.
According to the Bigtree MoBo doc, by removing the MCU power jumper as suggested there's no way to flash the board with the pi as suggested in Step 1
Comparing the two previous illustrations (the last being the board w/jumpers installed as they should be) suggests that I do NOT want to set the jumpers for UART mode?
Page 1 of 3
Next