Skip to main content

You're viewing a previously published revision of this guide.  View latest revision

Older Newer
  1. Remove the plastic stops installed in the ends of the linear rail 3x Linear rail - HG15 400mm Do not allow the linear rail carriage to leave the end of the rail
    • Remove the plastic stops installed in the ends of the linear rail

    • 3x Linear rail - HG15 400mm

    • Do not allow the linear rail carriage to leave the end of the rail

    • 21x M4x16 Cap Head Screw

    • Insert an M4x16 screw in every other hole in the linear rail

    • 21x 3030 M4 Drop in T-Nut

    • Loosely thread a 3030 T-Nut onto each of the M4x16 screws

    • Repeat these steps for the other 2 rails

  2. Insert wisdom here Insert wisdom here Insert wisdom here
    • Insert wisdom here

  3. Insert wisdom here Insert wisdom here Insert wisdom here
    • Insert wisdom here

  4. Insert wisdom here Insert wisdom here Insert wisdom here
    • Insert wisdom here

  5. Insert wisdom here
    • Insert wisdom here

  6. Insert wisdom here Insert wisdom here Insert wisdom here
    • Insert wisdom here

  7. Insert wisdom here Insert wisdom here Insert wisdom here
    • Insert wisdom here

  8. Insert wisdom here Insert wisdom here Insert wisdom here
    • Insert wisdom here

  9. Insert wisdom here Insert wisdom here Insert wisdom here
    • Insert wisdom here

Rat Rig

Member since: 7/10/20

48,550 Reputation

105 Guides authored

View Statistics:

Past 24 Hours: 120

Past 7 Days: 677

Past 30 Days: 3,471

All Time: 56,493