You're viewing a previously published revision of this guide.  View latest revision

Older
Sep 03, 2024 - 01:09:26
Sep 03, 2024 - 03:09:58 Sep 03, 2024 - 03:09:56 Sep 03, 2024 - 03:09:45 Sep 03, 2024 - 03:09:30 Sep 03, 2024 - 01:09:55 Sep 03, 2024 - 01:09:49 Sep 03, 2024 - 01:09:55 Sep 03, 2024 - 01:09:49 Sep 03, 2024 - 01:09:43 Sep 03, 2024 - 01:09:25 Sep 03, 2024 - 01:09:48 Sep 03, 2024 - 01:09:39 Sep 03, 2024 - 01:09:48 Sep 03, 2024 - 01:09:57 Sep 03, 2024 - 01:09:11 Sep 03, 2024 - 01:09:31 Sep 03, 2024 - 01:09:53 Sep 03, 2024 - 01:09:06 Sep 03, 2024 - 01:09:41 Sep 03, 2024 - 01:09:26 Sep 02, 2024 - 08:09:25
Newer

03. Toolhead wiring

Written By: Rat Rig
  • Comments: 2
  • Favorites: 0
  • Completions: 1

Steps

1

Sections

1

Flags

2

In Progress

In Progress

This guide is currently being written. Reload periodically to see the latest changes.

Private

Private

This guide will not appear in search results and can only be viewed by team members!

Quiz

0

  1. Phaetus Rapido V2 UHF Hotend

    • Phaetus Rapido V2 UHF Hotend

    • Cut the wires with 150mm and strip 5-10mm of the end, to expose the inside conductor.

    • Cut the thermistor wires with 160mm and crimp a JST 2 connector

    • The thermistor is a resistor that strongly varies with temperature. When crimping a resistor you don't have to worry about wire order as resistors don't have polarity.

Author

Rat Rig

Member since: 7/10/20

48,550 Reputation

105 Guides authored

View Statistics:

Past 24 Hours: 10

Past 7 Days: 78

Past 30 Days: 380

All Time: 9,004