06. Spool Holder Assembly

1x 120mm 3030 Extrusion

3030_spool_holder printed part

3030_end_cap printed part

2x 3030 Cast Bracket

4x M6x14 Countersunk Hex Head Screw

4x 3030 Drop-in T-Nut - M6

2x M5x10 Cap Head Screw

2x 3030 Drop-in T-Nut - M5

3030 Cast Bracket

M6x14 Countersunk Hex Head Screw

3030 Drop-in T-Nut - M6

Loosely thread the 3030 T-Nuts onto the M6x14 screws. Do not tighten them at this point

120mm 3030 Extrusion

Install the cast bracket assemblies onto the 3030 extrusion as shown

Fasten the two marked M6x14 countersunk screws

3030_end_cap printed part

Install the 3030 extrusion end caps by carefully pushing them into place

Install the spool holder assembly onto the V-Minion frame as shown

Fasten the two marked M6x14 countersunk screws to secure the spool holder to the frame

3030_spool_holder printed part

M5x10 Cap Head Screw

Insert the M5x10 cap head screws into the printed part.

3030 Drop-in T-Nut - M5

Loosely thread the 3030 T-Nuts onto the M5x10 screws. Do not tighten them at this point

Install the printed part onto the 3030 extrusion as shown

Fasten the two M5x10 screws to secure the printed part to the 3030 extrusion

Take care not to over tighten the M5x10 screws as you can damage the printed part