-
-
Low Profile Screw M5x20mm. You will use them to clamp your router inside the mount. No need to tighten them all the way down for now.
-
Low Profile Screw M5x8mm
-
Low Profile Screw M5x10mm
-
90ยบ Angle Corner Connector. Position it so it's perfectly flush with the back of the mount.
-
Drop-in T-Nut M5 - set in position, but don't tighten yet.
-
After assembling the mount, fit it inside the Z C-Beam slots, checking if it's perpendicular to it, and tighten the M5x8mm screws.
-
The Mount position depends on what jobs you are planning to do, however 1/3 of the way up the extrusion is a good position for normal work.
-
Almost done!
Finish Line
