Step Type:

Drag to rearrange

z_motor_cage printed part

2x M6x12 Cap Head Screw

2x 3030 Drop-in T-Nut - M6

Loosely thread the 3030 T-Nuts onto the M6x12 screws. Do not tighten them at this point.

Position the Z-axis motor mount as shown. The base should rest on the rear feet

Fasten both M6x12 screws to secure the mount to the frame

Take care not to over tighten the M6x12 screws as you can damage the printed part.

Your contributions are licensed under the open source Creative Commons license.