01. V-Core 3.1
View
Options
Preview new Authoring Experience
History
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
Introduction
Details
Guide Steps
Review
Quiz
The Rat Rig SuperPinda Probe needs to be at the correct height to trigger properly
A recommended method to set the correct height is to rest the hot end nozzle on the bed, and then place a cable tie between the bed and the tip of the probe
Adjust the probe up to down as necessary to position the tip 1mm higher than the hot end nozzle
Tighten the M3x8 to secure the probe in place
Do not over-tighten the M3x8 screw, doing so can damage the probe or printed probe mount
Correct probe vs nozzle position
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.