01. Rat Rig StrongHold PRO
View
Options
History
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
Introduction
Details
Guide Steps
Review
Quiz
300mm 1204 Ball Screw Assembly
FK10 Ball Screw Mount
Insert the threaded end of the ball screw through the hole in the FK10 mount
The ball screw is a precision fit into the FK10 mount. Do not force the ball screw in to the mount. When correctly aligned, it should slide in with little effort
Ball Screw Lock Nut
Fasten the ball screw lock nut on to the exposed end of the ball screw as shown
When the ball screw lock nut is fully tightened, use a 2mm hex key to tighten the grub screw within the lock nut. This will prevent the lock nut from loosening
From this point forward, make sure that the ball screw nut remains near the middle of the ball screw. Allowing the ball screw nut to reach the end of the ball screw will cause permanent damage to the ball screw
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.