Step Type:

Drag to rearrange

It is important to verify that the X-axis ball screw is fully aligned before continuing

Move the X-axis all the way to the left side by rotating the ball screw

If the X-axis becomes tight and difficult to move as it approaches the left end, do the following:

Loosen all four of the M4x25 screws securing the FK12 mount in place

Move the X-axis fully to the end

Re-tighten all four of the M4x25 screws on the FK12 mount

Move the X-axis all the way to the right side by rotating the ball screw

If the X-axis becomes tight and difficult to move as it approaches the right end, repeat the above instructions to adjust the FF12 mount

Your contributions are licensed under the open source Creative Commons license.