Step Type:

Drag to rearrange

Rat Rig StrongHold ONE CNC - Idler Plate

M8 Washer

M8x22 Cap Head Screw

4040 Drop-in T-Nut - M8

Make sure the counterbore for the bearing is on the same side as the T-Nut.

Loosely thread a 4040 T-Nut on to each of the M8x22 screws. Do not tighten them at this point.

Repeat these instructions for the second idler plate.

Set these assemblies aside until Steps 11 & 12

Your contributions are licensed under the open source Creative Commons license.