Step Type:

Drag to rearrange

Before continuing with the assembly, the frame must be squared and all screws full tightened

Using an engineers square, check that the side 40120 extrusions are square to the extrusions forming the base

On each side, tighten all of the following screws whilst continuing to check that the side extrusion remain square with the base:

4x M8x16 within the cast corners connected to the base

6x M12x45 on the motor and idler plates

2x M8x22 on the motor and idler plates

Once one side is fully secured and squared, proceed to repeat the process on the other side

After tightening all screws, check the entire frame once more for squareness. Correcting any issues now is easier than once the assembly is complete!

Your contributions are licensed under the open source Creative Commons license.