Our CNC kits do not come with a pre-designated location for mounting electronic components, affording a greater degree of versatility in customization to accommodate your particular Rig. These kits include both 3-wire and 4-wire cables, which you will need to cut to the appropriate length as the assembly progresses.

Do not pre-cut any cables as the guide will instruct you on when and where to make necessary cuts, preventing any cables from being trimmed too short.

It is advised to practice crimping and soldering before the wiring assembly. Bad crimps or soldering jobs are the most common faults in electronics malfunctions. Never plug or unplug any components while the machine is powered on, this will lead to damaged components and even safety hazards.

Avoid bending the cables into tight corners as you can damage them. If you do not feel confident with a certain step, ask someone experienced to assist you. Any mistakes during this assembly will permanently damage the components. The guide contains a lot of warnings meant to keep you alert and ensure a successful build!