Agree with Tom’s comment, this really should be a m5 x 14. However, I was able to use the 12mm by tipping the printer on its side, causing the square nut to come closer to the rail.
Just a tip so you don’t do what I did, go ahead and put and m5 nut on the end so you don’t have to worry about them falling out when you do the next step.
Agree with Tom’s comment, this really should be a m5 x 14. However, I was able to use the 12mm by tipping the printer on its side, causing the square nut to come closer to the rail.
Just a tip so you don’t do what I did, go ahead and put and m5 nut on the end so you don’t have to worry about them falling out when you do the next step.
Please specify if it should be a mini or micro shim. I’m assuming mini because there are only 4 micro but this part is a little confusing.