Also, coming from the hybrid setup....this step refers to the LONGER pulley cable. There is a shorter one that comes with the hybrid setup, but you will be using the main/longer one from the main/normal parts kit.
Is it just me, or is this difficult to do when you have come here from the hybrid setup instructions? For the hybrid setup, the last set of instructions has you installing the upper motor and plate above the "normal" motor. Therefore you cannot just slide the belt in from the top....you have to try and thread it through and around from any/all sides. It's super hard to do, in my opinion.
Maybe this is addressed in a later step, but what do we do with the single t-slot on the other side of the two? It seems pretty obvious that the low profile screw should screw into these single t-slot squares, but maybe they are used later on? Either way, it should be called out if they are used here or not, in my opinion :)
This step references M2x12 but I think it should be the M3x12 mentioned in the previous step?
Also, coming from the hybrid setup....this step refers to the LONGER pulley cable. There is a shorter one that comes with the hybrid setup, but you will be using the main/longer one from the main/normal parts kit.
Is it just me, or is this difficult to do when you have come here from the hybrid setup instructions? For the hybrid setup, the last set of instructions has you installing the upper motor and plate above the "normal" motor. Therefore you cannot just slide the belt in from the top....you have to try and thread it through and around from any/all sides. It's super hard to do, in my opinion.
Maybe this is addressed in a later step, but what do we do with the single t-slot on the other side of the two? It seems pretty obvious that the low profile screw should screw into these single t-slot squares, but maybe they are used later on? Either way, it should be called out if they are used here or not, in my opinion :)
The instructions say vc4_XY_motor_lower_left but the title says upper right motor for the plates?
The last instruction refers to a 45mm screw, but shouldn't that be the 85mm one?